Browse roofing posts tagged Saint Paul roofing. Sellers Roofing — Saint Paul’s family-owned, union-built, GAF-certified roofing contractor — has completed 1,100+ residential and commercial roofs since 2017.
Yes, sometimes. You can replace one roof slope in a hail damage roof claim when the damage stays limited to that section, the surrounding roof still performs well, and new materials won’t create matching, code, warranty, or drainage problems. If impact marks spread across multiple areas, or moisture moved below the surface, a larger repair…
You know your roof has hail damage when a recent storm is followed by random impact marks, dents on soft metals, bruising or punctures in the roofing surface, damaged flashing, or new interior leaks. On commercial buildings, the clearest signs often show up around seams, drains, rooftop units, and metal edges, not in one obvious…
Standing seam roof leak detection works by following the leak path, not just the water stain. A technician inspects seams, clips, penetrations, end laps, and roof transitions, then confirms hidden moisture with thermal scans, moisture meters, and selective test openings. Because water can move under metal panels, the drip inside rarely marks the true source….
(Saint Paul homeowners and property managers): hail damage asphalt shingles usually shows up as (1) round “bruises” where the shingle mat fractures under the surface, (2) clean granule loss spots with a defined impact area, and (3) a repeating pattern of similar-sized hits across the same roof slope (often on the windward side). The fastest…
Nail pops on asphalt shingles show up as small, raised bumps where a shingle tab lifts because nail heads have pushed up. In the Minnesota climate, freeze-thaw swings make them easier to spot during late winter and early spring. Look for uneven shingle lines, lifted corners, exposed nail heads, and tiny cracks or granule loss…
You detect a built-up roof leak without core cuts by layering built-up roof leak detection methods, not by guessing. Start with interior leak mapping, inspect the roof surface, scan for trapped moisture with infrared, confirm wet areas with a moisture meter, and use electronic leak detection when the roof surface allows it. That usually narrows…
Short answer: To detect a TPO roof leak at termination bars, start by tracing interior stains to the nearest roof edge or parapet. Then inspect the termination line for cracked sealant, loose fasteners, membrane shrinkage, and wall gaps. Confirm hidden moisture with infrared or electronic testing, because water often travels inside the roof assembly before…
Short answer: Detect an HVAC curb flashing leak by inspecting the curb’s corners, seams, and termination points, then confirming moisture paths with interior checks. Look for cracked roofing sealant, open welds, lifted membrane, rusted fasteners, and ponding that pushes water against the curb. If signs are mixed, use targeted moisture mapping or a controlled water…
A TPO roof leak at HVAC curb corners is found by narrowing the leak path from the interior, then inspecting every curb corner detail on the TPO membrane: welds, flashing, termination, fasteners, and sealant transitions. Finally, confirm the exact breach with controlled water testing or professional methods like infrared or electronic leak detection, because water…
Hail damage vs weathering process usually comes down to pattern and texture. Hail damage leaves random, coin-sized bruises and sharp granule loss in scattered spots. The weathering process looks even, with gradual fading and uniform granule loss along edges and high-flow areas. If you see circular impact marks, matching hits on vents, and fresh granules…
A skylight flashing leak usually shows up as a roof leak in the form of staining that starts at the skylight’s edges (often the uphill side) and worsens during wind-driven rain or thaw cycles. A skylight unit leak or condensation issue tends to leave moisture on the glass, frame, or inside corners first. The fastest…
Ponding water on a flat roof is rain or snowmelt, often referred to as “standing water”, that sits in low spots instead of draining away. In Minnesota, it becomes a real problem when it stays longer than 48 hours, keeps coming back after normal storms, or pools near seams, drains, and penetrations. A simple ruler…
Contact Sellers Roofing Company today for your free, no-obligation estimate!
Sellers Roofing Company is your premier Saint Paul destination for expert commercial and residential roofing services, offering comprehensive solutions from storm damage restoration and repairs to new asphalt shingle installations, all with meticulous craftsmanship and an eye for enhancing your property’s safety and aesthetic.