Welcome to our metal roof Blog Post archives, where you will find helpful and informative topics on metal roofing. We make it a point to educate our visitors about topics that we believe are pressing issues regarding metal roofing, because we know what it feels like as a homeowner to be faced with an important decision and be grasping at straws because you aren’t properly informed about the topic.
We hope that our metal blog topics get you filled in on what you need to know to make educated decisions about your metal roof!
Here are some of our most helpful metal blog topics:
What Are the Benefits of Corrugated Metal Roofing
Minimum Pitch for a Metal Roof
Metal Roof Cost in Minneapolis 2020
If you have any questions, comments, or concerns, or you would like to see us cover a topic regarding metal roofing that is not already on our blog, fill out our contact form here or call us during normal business hours at (651)703-2336to get in touch with someone from our expert staff!
We have friendly operators on standby to take your call and answer any questions you may have, or we can set up a good time to meet with one of our metal roofing experts at your convenience to discuss your project in person.
Yes. Exposed nails can leak after high winds because gusts can loosen fasteners, crack sealant, and open a path for water under flashing or metal trim. On commercial buildings, the trouble usually starts at edge details, penetrations, ridge caps, and older repair spots. The leak may show up far from the nail, so the source…
Yes. Heavy snow can cover wind-lifted seams, bent edge metal, loose flashing, and small punctures until thaw exposes them. On commercial roofs, the first clear sign may show up in spring as interior leaks, wet insulation, or shifted membrane. That’s why winter storm damage often needs photos, temporary dry-in, and a focused post-thaw inspection. When…
Yes. A satellite dish roof leak can show up after hail because the storm often damages the weak points around the mount, not the dish itself. Fasteners can loosen, sealant can crack, flashing can shift, and cable-entry details can open. On commercial roofs, water may travel away from the breach before it appears indoors. For…
Yes, hail can damage stone-coated steel roofs in Minnesota. The roof may still look fine from the ground, but hail can dent the steel, chip the coating, loosen flashings, or open a leak path around details. Some damage is cosmetic. Some damage affects watertightness. The difference matters, especially when a commercial roof needs repair after…
Yes. In Minnesota, an insurer can deny a metal roof hail claim if the policy excludes cosmetic damage and the storm only left dents or dings that did not change how the roof sheds water. That denial is not automatic, though. If hail harmed seams, fasteners, flashing, coatings, drainage, or caused leaks, the damage may…
Short answer: Yes, a hail-damaged metal roof can often be repaired, but not always. Repair makes sense when damage is limited to a few panels, fasteners, seams, or flashing details. Replacement is the better call when hail causes punctures, seam failure, widespread panel distortion, coating loss, or repeated leaks that raise long-term risk. When This…
Hail damage on flat roof edge metal usually looks like clustered dents, sharp dings, chipped coating, bent corners, and opened joints. On severe hits, coping caps and gravel stops may shift out of line or pull at seams. If the metal moved, cracked, or lost sealant, the damage is more than cosmetic. What Flat Roof…
Yes. Loose fasteners can leak even when every metal panel is still in place. When a screw backs out or its washer fails, it leaves a small path for water. Wind-driven rain, snowmelt, and freeze-thaw cycles can push moisture through that opening, so a commercial roof may leak long before any panel goes missing. When…
Yes. Hail can damage exposed-fastener metal roofs in Minnesota, especially at fasteners, neoprene washers, panel laps, and flashing. Some dents are only cosmetic. However, split washers, backed-out screws, bent seams, coating loss, and punctures are functional damage that can lead to leaks, rust, and shorter roof life. When This Applies Which buildings and roof layouts…
Sometimes. In Minnesota, commercial property insurance may pay for matching metal roof panels when your policy promises replacement with like kind, quality, or comparable materials and exact panels no longer exist. Insurance disputes often arise when trying to replace high-performance PVDF finishes with lower-tier SMP finishes or vice versa, as this affects the like kind…
On standing seam metal roofs, wind damage usually shows up as lifted panel edges, popped seams, loose clips, bent flashing, sudden waviness, and leaks near edges or penetrations. Severe damage can shift panels out of line or partly detach them. Even small seam movement matters because wind and water keep working the same weak spot….
Standing seam roof leak detection works by following the leak path, not just the water stain. A technician inspects seams, clips, penetrations, end laps, and roof transitions, then confirms hidden moisture with thermal scans, moisture meters, and selective test openings. Because water can move under metal panels, the drip inside rarely marks the true source….
Contact Sellers Roofing Company today for your free, no-obligation estimate!
Sellers Roofing Company is your premier Saint Paul destination for expert commercial and residential roofing services, offering comprehensive solutions from storm damage restoration and repairs to new asphalt shingle installations, all with meticulous craftsmanship and an eye for enhancing your property’s safety and aesthetic.