Articles tagged leak. Sellers Roofing diagnoses and repairs roof leaks across Saint Paul — same-day callback, no-pressure inspection, and written warranty.
Yes, in many cases you can detect a commercial roof leak detection issue without shutting down the building. The safest approach is to map interior signs, inspect the roof surface, use infrared moisture scanning, and confirm problem areas with low-voltage electronic testing. That keeps disruption low and helps crews target the real leak, not just…
Good flat roof leak detection starts inside the building, then moves to the roof surface, moisture mapping, and final confirmation testing. White coatings can hide small cracks, failed seams, and wet insulation under a clean-looking surface, so visual checks alone often miss the source. Infrared scans, electronic testing, and moisture probes usually give the clearest…
Short answer: You’ll suspect roof decking rot when your roof system shows ongoing moisture infiltration plus structural “softness.” Inside, watch for recurring ceiling stains, musty smells, or bubbling finishes. On the roof, look for ponding water, failing seams, or spongy areas that flex under safe, limited foot pressure. In Minnesota, freeze thaw cycles and Minnesota…
Usually, a yellow ceiling stain means moisture got in at some point, but it isn’t always an active roof leak. If the stain is growing, feels damp, or shows up after rain or snowmelt, treat it as a current leak until proven otherwise. If it’s dry, crisp-edged, and hasn’t changed in months, it may be…
Short answer: To detect a TPO roof leak at termination bars, start by tracing interior stains to the nearest roof edge or parapet. Then inspect the termination line for cracked sealant, loose fasteners, membrane shrinkage, and wall gaps. Confirm hidden moisture with infrared or electronic testing, because water often travels inside the roof assembly before…
Start by inspecting the rubber pipe boots where they hug the pipe, then the base flashing where it meets the roof. Look for radial cracks, splits at the top edge, loose sealant, and lifting edges from freeze-thaw. On Minnesota commercial roofs, check after big temperature swings and after snow events, then document damage and schedule…
A dormer roof leak is usually found by tracing water backward from the first interior stain to the highest wet point, then checking the dormer’s flashing, valleys, and shingle courses above that spot. Start inside (attic or ceiling), mark the drip line, then inspect uphill around step flashing and the dormer cheeks. If needed, run…
To detect a commercial roof scupper leak, trace water from the inside out, then confirm the source at the roof edge. Start by mapping interior stains, inspect the scupper opening and roof flashing, and check the roof membrane upslope where water feeds the scupper. Finish with a controlled water test or professional moisture testing to…
A professional roof inspection and roof leak detection report for insurance should be performed by a licensed, insured commercial roofing professional (or an independent roof consultant) who can document cause, location, and extent of damage with photos, test results, and clear repair scope. Avoid relying on maintenance staff or a general handyman. Insurers want credible…
Short Answer: To find a commercial flat roof leak at an expansion joint, start by mapping where water shows up inside and when it happens. Then inspect the joint cover, roof flashing, and roof membrane terminations for splits, loose edges, or failed sealant. If it’s still unclear, use controlled testing (low-pressure water, infrared, or electronic…
Yes, ballasted EPDM leak detection can work with electronic leak detection (ELD), but not in a “scan right over the rocks” way. In most real-world cases, crews must move ballast in controlled sections to expose the EPDM membrane, wet this synthetic rubber surface, and then test. If the roof was built with ELD-friendly components, results…
A hidden roof leak in walls usually shows up as subtle changes before you ever see water damage. Watch for water stains near the ceiling line, bubbling or peeling paint, soft drywall, a musty smell, or damp insulation behind the wall. In commercial buildings, leaks often travel far from the roof entry point, so the…
Contact Sellers Roofing Company today for your free, no-obligation estimate!
Sellers Roofing Company is your premier Saint Paul destination for expert commercial and residential roofing services, offering comprehensive solutions from storm damage restoration and repairs to new asphalt shingle installations, all with meticulous craftsmanship and an eye for enhancing your property’s safety and aesthetic.